G13 Lamp Cap Gauge Bi Pin Go No Go Pin Gauge On Finished Lamps T8
G13 Gauge list:
| IEC60061-3,7006-45-4 | G13(T8) Go gauge for bi-pin cap on finished lamps |
| IEC60061-3,7006-44-5 | G13(T8) Go and not go gauge for unmounted bi-pin cap |
Conforms To:
IEC60968-1, IEC60061-3 G13
7006-45-4
Go gauge for bi-pin cap on finished lamps G13
PURPOSE:
To check dimensionb bc-, F min., max
and the combined pin diametera displacement of pins
(including bosges)of bi-pin caps G13 on finished lamps.
TESTING:
The pina of the capa on finished lampe shall enter the gauge at
surface and, when fully ingerted, the burface
of cap and gauge shall contact In this position the end of the pins
ahall be co-planar with
or project beyond surface, but shall not projoct beyond gurfacey.
Each individual pin shall enter hole ei at surface o until the face
of the cap and the aurface of the gauge contact.
7006-44-5
Go and not go gauge for unmounted bi-pin cap
PURPOSE:
To check dimensions min,emax,fmin.,gmax,max. and the combined pin
dismeter and displncement of pins (including bossea) of unmounted
bi-pin caps G13.
TESTING:
The pins of the cap shall enter the gauge at surfoce and, when
fully inserted, the aurfaces of cap and gauge shall contact. In
this position the ends of the pins ahall be co-planar with or
project
beyond surfoce X. Each individual pin shall enter the hole ea until
the boss of the pin and the surface
of the gauge contact, but they shall not enter hole. The boss of
the individual pin shall enter hole b
at surface until the surfaces of the cap and the gnuge contact.
Application:
Guangzhou Shice Equipment offers a wide range of gauge to meet the
most common standards including those from
IEC, EN, UL, GB,DIN,VDE and others.
Such standards require the checking of size & definition etc.
These gauges are constructed from senior stainless steel and
appropriate steel with a hardness of at least 60 HRC and a
roughness according to standard require.
Each gauge is supplied with a certificate of calibration.
